Intercambia consejos de herramientas, ajustes de post-procesador, diseños de fijación, piezas terminadas. Las respuestas son públicas; los temas requieren login.
Sé el primero en iniciar uno. Inicia sesión arriba y haz clic en Nuevo tema.
Vista previa mientras el foro coge impulso:
Tried the stock Pocket NC vise on a few prototype brackets and the serrated jaws leave witness lines. What soft-jaw setups work without sacrificing rigidity for a 50,000 RPM finishing pass?
Three months in on the V2-50 CHK and finally got a clean simultaneous swarf pass on a small turbine impeller. Posting Fusion 360 setup notes + the 5-axis postprocessor I'm using.
Sharing my modified .cps post for Fusion 360. Adjusts the A/B preamble so Kinetic Control reads simultaneous moves cleanly. Tested on V2-10 + V2-50 CHK.
Setting up a V2-50 CHK in a shop that has both. Pocket NC docs say single-phase 230 V is fine but I'm getting conflicting advice from local electricians. Anyone running off 3-phase with the included PSU?
Tell us about your project — we typically reply within 24 hours.