Community-Forum

Pocket NC Betreiber · im Austausch.

Werkzeug-Tipps, Postprozessor-Anpassungen, Vorrichtungen, fertige Teile. Antworten sind öffentlich; Themen erfordern ein Kundenkonto.

Anmelden, um ein Thema zu starten Konto erstellen

Noch keine Threads.

Seien Sie der Erste, der einen startet. Melden Sie sich oben an und klicken Sie auf Neuer Thread.

Beispielvorschau, während das Forum an Schwung gewinnt:

help sample

Vise jaws keep marking 6061 aluminium — soft-jaw alternatives?

Tried the stock Pocket NC vise on a few prototype brackets and the serrated jaws leave witness lines. What soft-jaw setups work without sacrificing rigidity for a 50,000 RPM finishing pass?

sample · operator 4 replies
show and tell sample

First 5-axis simultaneous part — turbine impeller in 7075

Three months in on the V2-50 CHK and finally got a clean simultaneous swarf pass on a small turbine impeller. Posting Fusion 360 setup notes + the 5-axis postprocessor I'm using.

sample · operator 11 replies
software · cam sample

Fusion 360 postprocessor tweaks for Kinetic Control

Sharing my modified .cps post for Fusion 360. Adjusts the A/B preamble so Kinetic Control reads simultaneous moves cleanly. Tested on V2-10 + V2-50 CHK.

sample · operator 7 replies
hardware · machine sample

EU power: 230 V single-phase vs 400 V three-phase — does it matter?

Setting up a V2-50 CHK in a shop that has both. Pocket NC docs say single-phase 230 V is fine but I'm getting conflicting advice from local electricians. Anyone running off 3-phase with the included PSU?

sample · operator 3 replies