Probe-zeroing accuracy — am I expecting too much?
Getting ±15 µm repeatability on touch probe zeroing. Spec sheet implies ±5 µm. What's normal for the V2-10?
Artikel lesen →Journal
Journal
Ausführliche Texte zu 5-Achsen-Fräsen, EU-Fertigungslogistik und den Entscheidungen, die hinter jedem Pocket-NC-Kauf stehen.
ER11 collet — when do you replace it?
Looking for a practical replacement threshold. Hours? Visible wear? Measured runout? Curious what others use.
Artikel lesen →Mist coolant on the V2-10 — which fluid for aluminium?
Looking for an EU-sourced mist coolant that plays nice with both 6061 and 7075. What works in your shop?
Artikel lesen →