Échangez astuces d'outillage, optimisations post-processeur, designs de fixations, pièces finies. Les réponses sont publiques ; les sujets nécessitent une connexion client.
Soyez le premier à en démarrer un. Connectez-vous ci-dessus et cliquez sur Nouveau sujet.
Aperçu pendant que le forum prend de l'élan :
Tried the stock Pocket NC vise on a few prototype brackets and the serrated jaws leave witness lines. What soft-jaw setups work without sacrificing rigidity for a 50,000 RPM finishing pass?
Three months in on the V2-50 CHK and finally got a clean simultaneous swarf pass on a small turbine impeller. Posting Fusion 360 setup notes + the 5-axis postprocessor I'm using.
Sharing my modified .cps post for Fusion 360. Adjusts the A/B preamble so Kinetic Control reads simultaneous moves cleanly. Tested on V2-10 + V2-50 CHK.
Setting up a V2-50 CHK in a shop that has both. Pocket NC docs say single-phase 230 V is fine but I'm getting conflicting advice from local electricians. Anyone running off 3-phase with the included PSU?
Tell us about your project — we typically reply within 24 hours.